40" × 12"
Panel size
26-gauge
Steel
50 sq ft
Per box · 15 panels
40-year
Panel size
The system
One product, perfected.
A single 26-gauge steel shingle in three low-glare textured colors. Every panel, trim piece and flashing component is designed to work as one system.
​
Storage: keep panels and ridge caps under a weatherproof tarp, or somewhere dry and chemical-free, until installation day.
The system
More than a panel.
Use only LUXR-approved trim and flashing. It keeps the roof watertight and keeps warranty coverage intact.
Drip Edge
Locks the first course at the eave and sets the starting line.
Rake
Anchors panel ends at the gable and highlights the tapered profile.
Sidewall
Vertical flashing at chimneys, dormers, and walls.
Apron / 2-pc Endwall
Front-of-penetration flashing at chimneys, skylights and dormers.
Valley
Double-J valley flashing for strong ice and water protection.
Cleat Offset
Locks panels where no drip edge is present.
Avoid dissimilar metals:
Never use copper, aluminum or lead accessories with a LUXR roof. Incompatible metals can cause panel failure.
How it works
Six steps to a LUXR roof.
01
Prepare the deck
Photograph the property first. Replace damaged sheathing; ½" plywood minimum, or 15/32" OSB. Roof-over allowed where code permits.
02
Install the underlayment
Ice & water shield at eaves, valleys, pitch changes, and penetrations; synthetic everywhere else. Below 4:12, peel-and-stick over the whole roof.
03
Set the trim
Snap chalk lines, then install eave starter, rake, valley and sidewall flashing, always lapping upper pieces over lower.
Install the field panels
Start bottom-left and work left to right, eave to ridge. Fully interlock every panel and stagger the side laps.
04
Flash every penetration
6" underpans under any cut top lock, 20" at vent pipes. Apron, sidewall and backflash at chimneys and skylights. Seal every overlap.
05
Finish hips, ridges & venting
Bend the ridge base to pitch and overlap about 6". Soffit intake should equal or exceed ridge exhaust.
06
4 screws minimum. 7 recommended.
LUXR hex-head screws through the pre-drilled flange, at least 3 threads through the sheathing.
Stagger for a natural look.
Start bottom-left and work left to right, eave to ridge. Fully interlock every panel and stagger the side laps.
Recommended tools
Equip your crew.
Brakes & forming
10' brake · 2' brake · 15" and 3" hand benders
Measuring & marking
Squares · 3' straightedge · tape · chalk line · markers
Cutting & fastening
Drill with turbo shears · impact driver · offset snips · pop riveter · caulk gun
Cutting & fastening
Drill with turbo shears · impact driver · offset snips · pop riveter · caulk gun
Cutting & fastening
Drill with turbo shears · impact driver · offset snips · pop riveter · caulk gun
Recommended tools
Step in the center of the panel — never on the side locks.
Metal is slippery when wet or dusty. Use fall restraint, wear soft rubber-soled shoes and block off the area below the work zone.
Standards & warranty
Backed for 40 years.
Every LUXR roof carries a Sherwin-Williams 40-year limited warranty. Final certified ratings and fastener schedules will be published in the LUXR Installation Manual v2.
Wind uplift
Third-party testing in progress
Impact resistance
Third-party testing in progress
Corrosion resistance
Third-party testing in progress
Regional approvals
High-wind / hurricane-zone approvals pending
Cutting & fastening
To be filed with the Cool Roof Rating Council
Cutting & fastening
With code-specified fire-rated underlayment
FAQ